First post, by TehGuy
So I got one of those modded PIII-S chips from the korean guy on ebay and wanted to give it a go. Board boots up and correctly identifies it, but then froze up after the memory testing. Rebooted the machine and it wouldn't even POST. Swapped my Via C3 back in and everything was fine. Currently using the powleap3.bin BIOS from http://www.vogonsdrivers.com/getfile.php?fileid=727 in case it turns out to not have the needed microcode or something
Slotket is a later revision MSI Master (MSI-6905), was just using it to run a Coppermine P3 866MHz, board is set to 133 FSB and 9.5x mult via DIP switches in case it matters. Slotket is jumpered for 133 FSB and 1.45v (which the board's PWM should absolutely support). Have made sure the CPU is fully inserted and the cooler's retention mechanism plays nice with the little bit of extra height. Just out of ideas now, other than maybe try the Shuttle C003-HOT slotket I have since it also has a voltage DIP block that goes low enough for tualatin
Win98+DOS: C3 Ezra-T 1.0AGHz / P3-S 1.26GHz, 128MB RAM, AWE64 + Orpheus + Audigy 2 ZS, Ti 4200, 128GB SD card
Win XP SP3: C2Q 9650, 4GB RAM, X-Fi Titanium, GTX 750
PowerMac G4 QS 800MHz + GeForce4 Ti4200, OS 9
PowerMac G5 DP 1.8Ghz + ATi x800 XT, Leopard